Slide type pneumatic double thermosol machine
Two. Main uses:
The pneumatic dual position heat soluble glue machine can transfer the color patterns and characters of sublimation and solvent ink to cotton, hemp, chemical fiber, nylon and other fabrics and ceramic products. It also can be used for heat treatment of hair burning and foaming printing, and the adhesion of low temperature and low pressure linings to the fabric, such as clothing, shoes and hats.
Three. The characteristics of the product:
Electronic digital display constant temperature control temperature, high accuracy, (+ 2); heat use imported aluminum alloy casting heat conduction principle, electricity saving, temperature uniformity, temperature difference coefficient small; electronic digital time control, high accuracy, beautiful; pressure random adjustment
Four. Technical parameters:
Power: 2000-3500W
Voltage: 220V/110V
Temperature range: 0-399 degrees
Time range: 0--999Sec
Hot stamping area: 38*38 CM 40*50 CM 40*60 CM
Five. Operation steps
1, connect the compressor connector, open the air pressure, adjust the pressure regulator 6 to (4pB-6pB), and make the heating plate rise.
2, connect the compressor connector, open the barometric pressure, modulate the pressure gauge (4pB-6pB), and raise the heating plate.
3, power up, turn on the main switch, and the indicator will light up.
4, adjust the time and temperature required. (for details see the last page.)
5, after adjusting the temperature and time, wait for the machine to heat up.
6. After the temperature is finished, the thermometer will light a small green light.
7, the clothes are placed on the 11 silica gel pad, then put on the hot drawing paper, (pay attention to the right and reverse side of the drawing paper) to push the table to the hot press position, press the start switch, press the articles flat, put the hot drawing paper, then put the high temperature cloth, press the start switch, the stamping start, the time reverse.
8, at the end, the buzzer rings. The heating plate is automatically raised and pulled out of the working table.
9. The perm. If the hot tear paper is cold, please wait 5-10 seconds to tear up the hot paper. If it is the hot tear hot paper, if the hot stamping is finished, please tear the ironing paper immediately.
10, after successful printing, you can turn the button 9 to the semi-automatic stop. After placing hot stamping objects, hot stamping will start automatically as long as the mobile handle 12 is above the hot stamping object. You can press the button 8 to stop in emergency.
Six. Maintenance items:
1, pressure: not uniform enough, first use a ruler to measure the distance from the four sides of the plate. If not, we can adjust the "lower" nut of the four wire rod in the center of the heating plate. The pressure is too large or too small (usually 4KG-6KG), adjusting the regulating valve on the "+" direction, increasing pressure, "-" to reduce pressure, or to check the pressure of the air compressor is normal (usually the air compressor pressure is 6KG-8KG).
2, time: when the floor is in place, do not show time, check the close switch, whether the distance is moderate, should be adjusted to less than 4 millimeters, time to, the heating board does not come down, check the circuit.
3, temperature: turn to set temperature, do not heat up, do not control temperature, check the temperature control table, contactor, heating plate line is good contact and electrical original fault.
